2004 Skidoo ZX Series Service Manual, Page 394Get this manual
Section 08 TRANSMISSION Subsection 02 (DRIVE PULLEY)
A16D2PB A32D1ZA
MODEL With TRA With TRA III and IV
ANGLE (A) 30 45 3
All Models Always install lever assemblies so that cotter pins are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, drive pulley misbalancing will occur because of levers differenceAll Models Except 593 HOSDI and V-1000 Engine Equipped ModelsA16D09A