2004 Skidoo ZX Series Service Manual, Page 393Get this manual
Section 08 TRANSMISSION Subsection 02 (DRIVE PULLEY)
26,27,28, Calibration Screw, Washer and Locking Nut
When installing calibration screw, make sure to install washer as shown1
A32D2YA
1Bushing
Install the circlipA16D07A
TYPICAL 1Washer
Torque locking nut to 10 Nm (89 lbfin)1
Always use the same type of pin as originally installed when servicingDifferent types have different weights for calibration purposeRefer to TECHNICAL DATA
21,22,23, Screw, Dowel Tube and Ramp
A32D2ZA