2004 Skidoo ZX Series Service Manual, Page 360Get this manual
Section 07 ENGINES MANAGEMENT (4-TEC) Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
After performing the required resets, ensure to clear all faults from the newly replaced ECMStart the engine and increase engine speed above 5000 RPM to be sure no fault appears
ENGINE WIRING HARNESS
A32C7OA
1Vehicle harness
Disconnect the wiring harness from all sensors actuatorsDisconnect the ECM connector from the ECMCut all locking ties which are holding the wiring harness in position1