2004 Skidoo ZX Series Service Manual, Page 326Get this manual
Section 06 ENGINES MANAGEMENT (2-TEC) Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
The resistance should be between 190 and 300 Otherwise, replace the CPSIf resistance tests good, reconnect the CPS and disconnect the connector DA on the ECM1
A32C9VA
R1503motr182A
1CPS inside crankcase
Using multimeter, recheck resistance value between terminals and 19If resistance value is correct, try new ECMRefer to ECM REPLACEMENT procedures elsewhere in this sectionNOTE: Check if wiring harness shows any signs of scoring prior to replace the ECMIf resistance value is incorrect, repair the connectors or replace the wiring harness between ECM connector and the CPS