2004 Skidoo ZX Series Service Manual, Page 291Get this manual
Section 05 ENGINES (4-TEC) Subsection 08 (CRANKCASE)
GENERAL
To remove crankcase, the engine removal is necessaryFor installation, use the torque values and Loctite products indicated in the exploded viewClean threads before using Loctite when installing screws
PTO COVER
Removal
Remove: engine from the vehicle (refer to REMOVAL AND INSTALLATION) oil tank (refer to LUBRICATION SYSTEM) disconnect crankshaft position sensor no23 PTO cover screws no17 and no17A and pull PTO cover no16R1004motr112A
1Plain bearing 2Oil bore APlain bearing inside diameter to be measured in area of oil bore
PLAIN BEARING INSIDE DIAMETER (PTO side support bearing) SERVICE LIMIT 38.040 mm (1.4976 in)
Bearing Removal Procedure Carefully remove the oil seal no20 with screwdriver, without inflicting damage to the PTO coverTOOLS PN TO REMOVE PTO SIDE PLAIN BEARING PTO side plain bearing remover 529 035 914