2004 Skidoo ZX Series Service Manual, Page 263Get this manual
Section 05 ENGINES (4-TEC) Subsection 06 (CYLINDER AND CYLINDER HEAD)
R1004motr79A
R1004motr81A
1Chain tensioner plug
WARNING
Never perform this operation immediately after the engine has been run because the exhaust system can be very hotWait until exhaust system is warm or cold spring no8 screws no7
Check chain tension guides no24 for wearReplace as necessaryCheck spring conditionReplace if broken or worn
Installation
NOTE: At installation, replace the O-rings no4 and no9Slightly grease the O-rings before assembly using super lube greaseFor installation, reverse the removal procedurePay attention to the following detailsTorque chain tensioner housing screws to Nm (80 lbfin)NOTE: Screw the plunger until it touches the chain tension guideInstall spring end in plunger groove and the other in the plug grooveScrew plugThere must be no distortion of the spring during installation