2004 Skidoo ZX Series Service Manual, Page 249Get this manual
Section 05 ENGINES (4-TEC) Subsection 05 (LUBRICATION SYSTEM)
Replace oil filter housing if damaged
Installation
The installation is the opposite of the removal procedurePay attention to the following detailsNOTE: Always replace gasket no1Torque oil filter housing screws to Nm (80 lbfin)
ENGINE OIL PRESSURE REGULATOR
The oil pressure regulator is located on the engine alternator side (behind ignition coverpressure oil pump cover)
R1004motr56A
OIL FILTER HOUSING
Removal
First drain the lubrication system (refer to OIL CHANGE)Remove: oil tank (refer to OIL TANK) oil filter (refer to OIL FILTER) oil filter housing screws no3 and no4 and pull oil filter housing no2
R1004motr43A