2004 Skidoo ZX Series Service Manual, Page 239Get this manual
Section 05 ENGINES (4-TEC) Subsection 04 (COOLING SYSTEM)
Installation
7 12 10 11
The installation is the opposite of the removal procedurePay attention to the following detailsCAUTION: Be careful not to damage impeller wings during installationTighten impeller to Nm(62 lbfin)
IGNITION COVER
Removal
Remove: drain lubrication system (refer to OIL CHANGE) alternator (refer to ALTERNATOR) water pump housing no11 impeller no10 screws no3 and pull ignition cover no1Carefully remove the ignition cover using screwdriver and plastic hammer
R1004motr133A
WATER PUMP IMPELLER
Removal
Remove: water pump housing no11 impeller no10Using pliers, carefully turn the impeller anti-clockwise to remove it from the water pump shaft without any damageThe thread of the water pump shaft is right-hand