2004 Skidoo ZX Series Service Manual, Page 207Get this manual
Section 04 ENGINES (2-STROKE) Subsection 09 (CARBURETOR AND THROTTLE CABLE)
As confirmation, the gap between the stopper and the bracket should be within and 0.5 mm (0 and 164 in)
A32G2FA
steering cover and its padding retaining circlip
A32C32A
AWithin and 0.5 mm (0 and 164 in)
Reinstall air silencerCAUTION: Make sure dual carburetor assembly properly slides into air silencer adapters; hold it in place and tighten clamps
Idle Speed Final Adjustment
CAUTION: Before starting engine for the final idle adjustment, make sure that oil pump is adjustedThe oil injection pump adjustment must be checked after each time carburetor idle is adjustedRefer to OIL INJECTION SYSTEMStart engine and allow it to warm then adjust idle speed to specifications by turning idle speed screw clockwise to increase engine speed or counterclockwise to decrease itRefer to TECHNICAL DATA for the specificationsCAUTION: Do not attempt to set the idle speed by using the pilot screwSevere engine damage can occur