2004 Skidoo ZX Series Service Manual, Page 200Get this manual
Section 04 ENGINES (2-STROKE) Subsection 09 (CARBURETOR AND THROTTLE CABLE)
If tool tip does not seat under choke plunger no12, adjust as follows: Make sure choke lever is at half open positionTurn choke cable adjustment nut by hand until tool properly seats under choke plungerNOTE: light pressure should be needed to position tool under plungerTighten choke cable lock nut and reinstall protector capSet choke lever to close and open positions and ensure that tool properly seats under plunger only when lever is set to half open positionSet choke lever to close position and, by pulling and pushing choke lever, make sure there is no tension on cable (free play)
Idle Speed Final Adjustment
A32C5NA
AIR SILENCER SIDE SHOWN