2004 Skidoo ZX Series Service Manual, Page 94Get this manual
Section 03 TROUBLESHOOTING Subsection 04 (ELECTRICAL SYSTEM)
IGNITION SYSTEM DIAGNOSTIC FLOW CHART
360CYLINDER
SYMPTOM NO START AND NO SPARK
Check for spark at spark plug
No spark Disconnect the 6-HC connector that has the BLACKWHITE, WHITEGRAY, and the BLACKGREEN wires to the tether cord switchPlace jumper wire between the BLACKWHITE and the BLACKGREEN wires and retest for sparkNo spark Spark returns Check that tether DESS cord switch, ignition switch and engine cut-out switch are in place and in the run positionNo spark Disconnect the 6-HG connector that has the BLACKYELLOW and the BLACK wires and retest for sparkNo spark Fault is on the motor side of ignition systemContinue with the followingNo spark Spark returns Fault is in the charging systemRefer to the charging system diagnostic flow chart to find the problemFault is in the tether cord switchInspect and retest
Spark returns
One of the switches was left in the off position