2004 Skidoo ZX Series Service Manual, Page 63Get this manual
Section 02 MAINTENANCE Subsection 02 (STORAGE)
IMPORTANT: Never cut the locking ties of coil connectorsThis would allow mixing the wires between cylinders Remove ignition coilsCAUTION: Ensure there is no dirt in coil holes prior to removing the spark plugsOtherwise, dirt would fall into cylinders and will damage the internal components Remove the spark plugs Apply BOMBARDIER LUBE storage oil (413 711 600 for Canada and 413 711 900 for USA) lubricant into the cylinders Reinstall spark plugs and ignition coils Reconnect ignition coil connectorsNOTE: Prior to inserting the ignition coil in its location, apply some Molykote 111 grease (PN 413 707 000) around the seal area that touches the spark plug holeAfter installation, ensure the seal seats properly with the engine top surface To reinstall engine cover, push it downward until it snaps Crank engine several times while keeping throttle fully depressed to distribute lubricant on exhaust valves
CAUTION: It is necessary to use flannel cloths or equivalent on windshield and hood to avoid damaging further surfaces to cleanTo clean metallic parts use BOMBARDIER Cleaner (PN 293 110 001) (spray can 400and (PN 293 110 002) (4 L)CAUTION: Do not use BOMBARDIER Cleaner on decals or vinylFor vinyl and plastic parts, use VinylPlastic Cleaner (PN 413 711 200(6 L)To remove scratches on windshield or hood use BOMBARDIER Scratch Remover Kit (PN 861 774 800)CAUTION: Never clean plastic parts or hood with strong detergent, degreasing agent, paint thinner, acetone, products containing chlorine, etcInspect the body and repair any damageTouch up all metal spots with touch-up paint where paint has been scratched offSpray all bare metal parts including shock chromed rods with BOMBARDIER LUBE (PN 293 600 016)Wax the body for better protectionUse nonabrasive wax such as silicon waxNOTE: Apply wax on glossy finish only