2004 Skidoo Tundra Skandic Series Service Manual, Page 405Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
REPAIR PROCEDURE FOR R.I.MURETHANE
R.I.Murethane is light colored (tan) on the inside with smooth surface
Large Crack
Sand and scuff outside and inside area by exceeding it 31.7 mm (1-14 in) on each side and 12.7 mm (12 in) at each end Make groove (appr90) on both sides of hood using knife or rough round file Enlarge the crack to 2.4 mm (332 in) 3.2 mm (18 in) using sharp knife Clean outside and inside surface with isopropyl alcohol or Crest Hi-Solv product Repair inside surface first Cover inside area with Crest TP-E epoxy Apply 50 mm 30 mm (2 in 1-14 in) patchIf no room for the patch, use tape Cover exterior surface with same productDamaged area should be slightly higher Heat surface with heater lamp placed at 38 mm (15 in) for period of 15 minutes Sand outside surface using smooth dry sand paper Use same product if final finish is required Apply flexible primer Wait 10 minutes Repaint (air dry during 72 hours approximately)NOTE: R.I.Mmaterials are high static plastics, painting must be done in dust free area such as paint boothCrest products used in R.I.Mrepair procedure are available from following locations: