2004 Skidoo Tundra Skandic Series Service Manual, Page 402Get this manual
Section 09 BODYFRAME Subsection 02 (BODY)
INSTALLATION AND ADJUSTMENT HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed lineBULB REPLACEMENT
Tundra If headlamp is burnt, tilt hoodUnplug connector from headlampRemove protector cap and unfasten bulb retainer clipsDetach bulb and replace
A02E09A
TYPICAL 1Retainers clips
A02E0AA