2004 Skidoo Tundra Skandic Series Service Manual, Page 388Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
NOTE: To make sure skis are in straight-ahead position, place straight edge against pre-adjusted track and measure distance between front and rear of skis and straight edgeMeasurements are taken 200 mm (8 in) at rear and front of ski pivot boltDistances should be equalAfter ski toe-out adjustment, distance at front of ski must be 3.0 mm (18 in) more than at rear on both sides for total toe-out of mm (14 in)
Skandic SUV 550SUV 600 Adjustments should be performed following this sequence: Handlebarpivot arm positioning Idler arm positioning Set toe-out adjustmentHANDLEBARPIVOT ARM POSITIONING Turn handlebar until pivot arm is pointing straight forwardCheck if handlebar is horizontalTo adjust, loosen lock nuts of short tie rod and turn it accordingly
WARNING
A06G03A
Maximum ball joint external threaded length not engaged in the tie rod end must not exceed 20 mm (2532 in)Torque lock nut to 18 Nm (159 lbfin)