2004 Skidoo Tundra Skandic Series Service Manual, Page 384Get this manual
Section 08 STEERINGFRONT SUSPENSION Subsection 02 (STEERING SYSTEM)
Install rivet no11 if applicable
1, Steering Column
Remove steering pad then handlebar ass'yDetach tie rod(s) from the steering columnTo gain access to lower U-clamp or half bushing (as applicable), remove the air intake silencer and carburetor(s)Skandic Models Only Loosen rear engine fastening screwsSkandic WTWT LCSWTWTSUV 550 SUV 600 Models Remove half bushing then steering columnTundra and Skandic LTLT Models Remove U-clamps then steering column.A02G0SA
TYPICAL A20 mm (2532 in) maximum
The ball joint should be restrained when tightening the tie rod end lock nutAlign it so the tie rod end is parallel to the steering arm when assembled on the vehicle, refer to the following illustrationFor proper torque specifications refer to the specific exploded view for the vehicle being serviced1 2