2004 Skidoo Tundra Skandic Series Service Manual, Page 377Get this manual
Section 07 REAR SUSPENSION Subsection 06 (TRACK)
Check that the track is well centered; equal distance on both sides between edges of track guides and slider shoes1 2
A01F05A
A29F14B
1Guides 2Slider shoes 3Equal distance
To adjust track alignment: Remove the tether cord cap Loosen rear idler wheel retaining screws Loosen the lock nuts (on so equipped models) Tighten the adjustment screw on side where the slider shoe is the farthest from the track insert guides1 1
TYPICAL 1Retighten (so equipped models) 2Retighten to 48 Nm (35 lbfft)
Restart engine and rotate track slowly to recheck alignmentReposition snowmobile on ground
Track Cleat