2004 Skidoo Tundra Skandic Series Service Manual, Page 374Get this manual
Section 07 REAR SUSPENSION Subsection 05 (DRIVE AXLE)
The bearing on the splined side of axle must be pushed until it is seated on shaft shoulderThe end bearing housing bearing must be flush with end of drive axleEach bearing must have its shield facing the sprocket1 1
Reinstall the chaincase coverRefill with chaincase oilRefer to TECHNICAL DATAInstall the suspensionRefer to TRACK and adjust track tension and carry out track alignment procedure
LUBRICATION
15, Grease Fitting
Lubricate end housing bearing with suspension synthetic grease (PN 293 550 033)A00F05A
ADJUSTMENT
SprocketTrack Alignment
CAUTION: Do not tamper with sprockettrack alignment if frame or suspension is damagedSprockets might be repositioned to fit lugs without removing drive axleUse drive axle sprocket adjuster kit (PN 861 725 700)