2004 Skidoo Tundra Skandic Series Service Manual, Page 373Get this manual
Section 07 REAR SUSPENSION Subsection 05 (DRIVE AXLE)
11, Bearing Protector
At assembly, flat side of bearing protector must be against bearing5,12, Bearing
Always push bearing by inner race
A00F0DA
TYPICAL TUNDRA
A33D0NA
TYPICAL ALL SKANDIC MODELS A1.5 mm (116 in) MAXIMUM
CAUTION: The same sprocket must not be pressed twice on the axleIf synchronization is found to be defective, use new sprocket