2004 Skidoo Tundra Skandic Series Service Manual, Page 355Get this manual
Section 07 REAR SUSPENSION Subsection 02 (TORQUE REACTION SUSPENSION)
7,8, Support and Front Arm Support
To remove rivets securing the supports, cut rivet heads off using cold chiselAt assembly, position the rivet head toward the outside of the assemblySupport the rivet head against metal block, as shown, and use flat head punch to secure the rivet in place
A03F3SA
TYPICAL 1Slider shoe 2Molding line (wear limit indicator)
A07F02A
Replace slider shoes when wear limit is reachedCAUTION: Slider shoes must always be replaced in pairs
Flat head punch Support Runner Metal block
SUSPENSION ASS'Y INSTALLATION