2004 Skidoo Tundra Skandic Series Service Manual, Page 340Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
IGNITION SYSTEM TESTING (Skandic WTSWT) RESISTANCE VOLTAGE TEST TO BE WIRE PART NOTE VALUE MULTIMETER VALUE MULTIMETER PERFORMED COLOR (ohms) SCALE (volts) SCALE All switches must be in run BK and 00.0 Running insulation BKYL 0.L positionStop switch At least one stop switch Continuity in stop BK and 00.0 00.000.5 must be operationalposition BKYL All switches must be in run WH and 00.0 30.060.0 Output 230.0330.0 00.0VAC positionGN Ignition generator coil WH and 00.0 Ground continuity 00.000.5 engine The term "engine" refers to the engine metal parts connected RDWH Trigger to the magneto housing00.0 Continuity and 140.0180.0 2.09.0 00.0VAC coil engine Ignition module Secondary CAUTION: Do not measure high voltage coil output 00.0 and high winding resistance 13.118.3 voltagevoltage coil with caps Spark Secondary plug cap CAUTION: Do not measure high voltage coil output 00.0 winding resistance Spark 8.9013.1 voltagewith caps plug cap High voltage Secondary BK CAUTION: Do not measure high voltage coil output 00.0 coil winding resistance 0.901.10 BK voltagewithout caps The measurement must be Secondary BK .100.250 taken on the spark plug cable 0.00VAC winding voltage engine (without the spark plug)00.0 Spark plug cap Cap resistance 4.06.0