2004 Skidoo Tundra Skandic Series Service Manual, Page 338Get this manual
Section 06 ELECTRICAL Subsection 06 (TESTING PROCEDURE)
Ignition Switch (key)
Disconnect switch housingUsing multimeter, check between MAG and GRD terminals if the circuit is open (0.Lin operating position and if the circuit is closed (0in off position
If readings do not correspond to the abovementioned indications, replace switchIf readings are acceptable, check other switches
Tether Cord Switch
Unplug switch block connected to main wiring harnessCheck using multimeter by connecting probes to 6-03-B-M and 6-03-A-M wiresThe multimeter should indicate an open circuit (0.Lin operating position and closed circuit (0in off position
A05E07A
TYPICAL
A05E09A