2004 Skidoo Tundra Skandic Series Service Manual, Page 328Get this manual
Section 06 ELECTRICAL Subsection 05 (ELECTRIC STARTER)
Starter Housing Assembly and Starter Housing
Align previously traced indexing marks1 2
A19E09A
A32E21A
1Shorter stud 2Bare wire
TYPICAL 1Aligned indexing marks
Skandic WT LCSUV 600 Reverse the order of disassembly to reassemble starterHowever, attention should be paid to the following operationsPrior to assembling, coat sliding surfaces on armature shaft splines, overrunning clutch, bushing and roller bearing with synthetic grease (PN 413 711 500)After placing collar no3 on armature shaft no11, fit new snap ring no2 on armature shaft, then make sure that it is properly securedSlide collar no3 over snap ring no2 and secure in place by punching it at two or three places