2004 Skidoo Tundra Skandic Series Service Manual, Page 283Get this manual

Section 05 TRANSMISSION Subsection 08 (GEARBOX) A29D17A

DRIVEN PULLEY SHAFT COMPONENTS

Remove screws no39 from intermediate shafts no30Fasten long M8 1.25 screw in axle end then drive it out, beginning with top oneA29D1AA

1Spacer

Do not disassemble bearings of intermediate gears needlesslyPry out bottom seal no33 from gearbox housingRemove circlip no9

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives