2004 Skidoo Tundra Skandic Series Service Manual, Page 269Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
7, Brake Pad
Models with Hydraulic Brake After brake pads installation, brake disc must be centered in caliperApply brake then check for proper brake disc positioningPush on appropriate caliper piston in order to move pad inward allowing proper brake disc positioning
24, Upper Clamp
Models with Hydraulic Brake Install upper clamp with its arrow pointing at front of vehicleTighten to Nm (71 lbfin) front screw before rear one2 1
A03D3QB
TYPICAL 1Arrow on upper clamp pointing at front of vehicle 2Tighten front screw first
A03D2KA
ADJUSTMENT
Models with Mechanical Brake Fully depress brake handle several times to obtain 13 mm (12 in) between brake handle and handlebar grip when brake is fully appliedA