2004 Skidoo Tundra Skandic Series Service Manual, Page 268Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
INSPECTION
7, Brake Pad
Models with Mechanical Brake Brake pads must be replaced when fixed pad projects only mm (132 in) from caliperCAUTION: Brake pads must always be replaced in pairsASSEMBLY
14, Ratchet Wheel
Apply synthetic grease (PN 413 711 500) on threads and spring seat prior to installingFully tighten then back off one turn
Install so that it can only be removed upwardLock it in the caliper casting notch
INSTALLATION
To install brake, reverse removal procedure paying attention to the following
WARNING
Avoid getting oil on brake padsDo not lubricate or apply antirust or antifreeze solution in brake cable
17, Brake Disc
A15D03A