2004 Skidoo Tundra Skandic Series Service Manual, Page 267Get this manual
Section 05 TRANSMISSION Subsection 06 (BRAKE)
Installation
Install new brake pads Install spring and push pins to lock the brake pads Install retainers in the pin holesTo install brake, reverse removal procedure pay attention to the following
Pull countershaft assembly toward driven pulley side to gain access to clip no25 Remove clip no25 on countershaft
WARNING
Avoid getting oil on brake padsEach time new caliper or new brake pads are installed, proceed with the following: With caliper not bolted to chaincase, apply brake few times until both new pads are touching each other Push back pads and repeat above step Push back pads then fasten caliper to chaincase Proceed with bleeding as described in this subsection
A03D11A
Pull countershaft toward driven pulley side to free from chaincase and disc Remove disc