2004 Skidoo Tundra Skandic Series Service Manual, Page 262Get this manual
Section 05 TRANSMISSION Subsection 05 (PULLEY DISTANCE AND ALIGNMENT)
Skandic LTLT E
Pulley Alignment Method
Tundra Engine Movement Loosen the support retaining boltsMove the engine to obtain specified pulley alignment, torque engine support bolts to 55 Nm (41 lbfft) and remove engine support positionerDriven Pulley Movement Shims can be mounted between chaincase and frameUse shim (PN 504 039 800), 0.53 mm (.021 in) thick2
A15D02A
TYPICAL 1Engine movement 2Contact
NOTE: Prior to performing pulley adjustment, loosen torque rod nut to allow engine movementEngine supports have tendency to stick to frame, work engine loose prior to aligning1
Skandic LTLT When engine slotted mounting holes do not allow to set proper pulley offset X, adjust with shims (PN 504 108 200) between pulley and countershaft bearing support (pulley pushed toward brake disc)Engine Movement Loosen the bolts retaining engine support to the framePosition engine to obtain the specified alignmentNOTE: After alignment, adjust torque rod so it slightly contacts stopper plateDo not over tighten, it will disalign pulleys1