2004 Skidoo Tundra Skandic Series Service Manual, Page 258Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
Take 1st measurement when sliding half begins to turnRotate sliding half to 10 mm (38 in) of rotationHold spring scale at this positionSlowly release tension from spring scale and take nd measurement when sliding half begins to returnSpring pre-load is the average measurement between these 21st measurement (when opening)measurement Spring pre(when closing)load 3.8 kg (8.4 lb) (when opening) 3.4 kg(7.5 lb) (when closing) 2nd
A18C0AA
Example:
3.6 kg (8 lb)Actual spring pre-load
TYPICAL Letters and numbers shown in illustration are actual letters and numbers embossed on parts
NOTE: Always recheck torsional pre-load after adjusting
1 529 006 500
Pulley Alignment and Drive Belt Height
Refer to PULLEY DISTANCE AND ALIGNMENT and DRIVE BELT to perform adjustmentsDrive belt height is adjusted by turning Allen screws no13 equally and accordinglyCAUTION: Drive belt and pulley adjustments must always be checked whenever pulleys have been removed, replaced or disassembled