2004 Skidoo Tundra Skandic Series Service Manual, Page 249Get this manual
Section 05 TRANSMISSION Subsection 04 (DRIVEN PULLEY)
REMOVAL
Remove guard and drive belt from vehicleRemove the screw, and washer then pull the driven pulley from the shaft2 3
DISASSEMBLY
Use spring compressor (PN 529 035 524)Remove snap ring no2 and washer no3 to disassemble the outer cam and the pulley halves
A15D0OA
1Measure thickness of slope base here 2Sliding pulley side 3Slope base
WARNING
Driven pulley cam is spring loaded, use abovementioned tool
ASSEMBLY
4, Cam Slider Shoe
When replacing slider shoes, always install new set (3 shoes) to maintain equal pressure on the camAssemble driven pulley components by reversing the disassembly procedure
CLEANING
6, Bushing
During break-in period (about 10 hours of use), teflon from bushing moves to cam or shaft surfaceA teflon over teflon running condition occurs, leading to low frictionSo it is normal to see gray teflon deposit on cam or shaftDo not remove that deposit, it is not dustWhen dust deposit has to be removed from the cam or the shaft, use dry cloth to avoid removing transferred teflon