2004 Skidoo Tundra Skandic Series Service Manual, Page 241Get this manual

2004 Skidoo Tundra Skandic Series Service Manual, Page 241

Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Lift sliding half against spring cover and align spring cover arrow with sliding half mark529 005 500

A16B02A

A16D0DA

Install and torque screws to 13 Nm (115 lbfin)
Make sure to align governor cup arrow with sliding half and fixed half markNOTE: If fixed half has no mark, align governor cup mark with segment no1 of inner halfSegments are identified on engine side
6,25,29, Sliding Half, Slider Shoe and Governor Cup
To install governor cup, use following tool:

Back to 2004 Skidoo Tundra Skandic Series Service Manual