2004 Skidoo Tundra Skandic Series Service Manual, Page 240Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
21,22,23, Screw, Dowel Tube and Ramp
Insert dowel tube from chamfered sideMake sure ramp is centered on dowel tube9,11,13,14, Screw, Lever Ass'y, Nut and Cotter Pin
Always install lever assemblies so that cotter pins are on the shown sideInstall cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING
A16D08A
1Chamfered side
Position dowel tube split at the illustrated angle45 3
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, drive pulley misbalancing will occur because of levers difference1 2