2004 Skidoo Tundra Skandic Series Service Manual, Page 239Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
Spring Cover Bushing Replacement Under normal use there is no need to replace this bushingIf it must be replaced, it is recommended to replace the spring cover ass'y
ASSEMBLY
NOTE: This drive pulley is lubrication freeDo not lubricate any component
1,2,3, Screw, Ring Gear and Loctite 271
Apply Loctite 271 (PN 413 702 900) on threads and then torque to 27 Nm (20 lbfft)A32D2XA
NOTE: Make sure that the bushing is well seated on the sliding half ass'y