2004 Skidoo Tundra Skandic Series Service Manual, Page 236Get this manual
Section 05 TRANSMISSION Subsection 03 (DRIVE PULLEY)
5,6, Fixed and Sliding Half
CAUTION: Do not tap on governor cupScrew puller into fixed half shaft about 13 mm (12 in)Raise drive pulley and hold it by the sliding half while knocking on puller head to disengage fixed half
NOTE: To ease disassembly, forks (PN 529 005 500) should be used to hold slider shoes prior to removing governor cup
529 005 500
A16B02A
19, Spring Cover Ass'y
It is pushed by clutch spring pressureA16D01A
WARNING
Clutch spring is very strongNever attempt to remove spring cover without the recommended toolsUse spring compressor (PN 529 035 524)Install support guide