2004 Skidoo Tundra Skandic Series Service Manual, Page 216Get this manual
Section 04 ENGINE Subsection 11 (CARBURETOR AND FUEL PUMP)
FUEL PUMP REMOVAL
Install hose pincer (PN 295 000 076) on fuel supply line close to pump inlet
To check impulse diaphragm and gasket on highsupply fuel pump equipped with twin outlets, proceed as follows: Connect clean plastic tubing to the impulse nipple and plug vent hole on top coverEither apply pressure or vacuum using the pump (PN 529 021 800) from the engine leak tester kitThe diaphragm gasket must not leak
295 000 076
CLEANING AND INSPECTION
The entire pump should be cleaned with general purpose solvent before disassemblyFuel pump components should be cleaned in general purpose solvent and dried with compressed air
WARNING
A01B2JA