2004 Skidoo Tundra Skandic Series Service Manual, Page 115Get this manual

2004 Skidoo Tundra Skandic Series Service Manual, Page 115

Section 04 ENGINE Subsection 02 (277 ENGINE TYPE)
Install locating sleeveThen push needle bearings along with thrust washers and sleeve
A02C2FA

TYPICAL 1Locating sleeve 2Sleeve

A02C2GA

NOTE: 0.25 and 0.5 mm oversize pistons and rings are available if necessaryUse locking tie to fasten all needles and thrust washers along with locating sleeve
TYPICAL 1Sleeve

INSPECTION

Back to 2004 Skidoo Tundra Skandic Series Service Manual