2004 Ski-Doo REV Series Factory Service Manual, Page 418Get this manual
Section 11 TECHNICAL DATA Subsection 04 (TECHNICAL DATA LEGENDS)
TECHNICAL DATA LEGENDS
ENGINE LEGEND
ABDC: ATDC: BBDC: BTDC: CDI: IACV: K: MAG: N.A PTO: SDI: W: (1) After Bottom Dead Center After Top Dead Center Before Bottom Dead Center Before Top Dead Center Capacitor Discharge Ignition Idle Air Control Valve Kilo (x 1000) Magneto Not Applicable Power Take Off Semi-Direct Injection Watt The maximum horsepower RPM applicable on the vehicleIt may be different under certain circumstances and BOMBARDIER reserves the right to modify it without obligationCrankshaft end-play is not adjustable on these modelsSpecification is given for verification purposes onlyAt 3500 RPM with headlamp turned onAll resistance measurements must be performed with parts at room temperature (approx20C (68F))Temperature greatly affects resistance measurementsPress fit type, not replaceableNeedle with one groove, not adjustable(9) (8) (7) Drive pulley retaining screw: torque to 80 to 100 Nm (59 to 74 lbfft), install drive belt, accelerate the vehicle at low speed (maximum 30 kmh (20 MPH)) and apply the brake; repeat timesRetorque screw to 90 to 100 Nm (66 to 74 lbfft)CAUTION: Do not attempt to adjust gap on spark plug BR ECSThe specification is given for verification purpose onlyIf found out of specification, replace with new oneThe engine speed for transmission calibration applicable on the vehicleIt may be different under certain circumstances and BOMBARDIER reserves the right to modify it without obligation