2004 Ski-Doo REV Series Factory Service Manual, Page 356Get this manual

2004 Ski-Doo REV Series Factory Service Manual, Page 356

Section 10 BODYFRAME Subsection 01 (BODY)
INSTALLATION AND ADJUSTMENT HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed line
BULB REPLACEMENT
Headlamp
If any headlight bulb is burnt, proceed as followsRemove windshieldSee belowPull out steering support cap

A32H45A

Back to 2004 Ski-Doo REV Series Factory Service Manual