2004 Ski-Doo REV Series Factory Service Manual, Page 352Get this manual

2004 Ski-Doo REV Series Factory Service Manual, Page 352

Section 09 STEERINGFRONT SUSPENSION Subsection 02 (FRONT SUSPENSION)
A33F28A

1Install bushing as shown

A33F2IB

Lower Arm
Position lower arm below stabilizer barPrior to installing ball joint in lower arm, ensure to clean the tapered surfaces with the Pulley flange cleaner product (PN 413 711 809)Surface contacts must be clean and free of dirt, oil and greaseApply the cleaner on rag then use the rag to clean the surfaces of ball joint and ski legTo install ball joint, proceed as follows: Install ball joint support (PN 529 035 875) on top side of lower arm (operating position) Position ball joint installer (PN 529 035 975) on bottom side of lower arm (operating position) Press joint in Install snap ring no13 with its opening toward front of vehicle

Back to 2004 Ski-Doo REV Series Factory Service Manual