2004 Ski-Doo REV Series Factory Service Manual, Page 336Get this manual
Section 09 STEERINGFRONT SUSPENSION Subsection 01 (STEERING SYSTEM)
DISASSEMBLY AND ASSEMBLY
NOTE: These models feature an integrated heating element in the plastic sleeve of the grip no13CAUTION: Removing grip from handlebar might damage the heating elementDo not remove needlesslyNOTE: If heating grip does not work and needs to be replaced, the grip can be cut with knife for removalThrottle Side: Unfasten windshieldNOTE: Throttle lever housing no21 must come off handlebar along with gripRemove cap no3 or steering padding no23 according to modelUnplug RH harness on top of steering columnCut locking ties retaining RH harness to handlebarRemove throttle lever housing cover no19
CAUTION: Pay attention not to damage wires with the wrenchUsing plastic hammer, tap on the side of the wrench end to make the grip slide out
A33G0AA
1Screw retaining throttle lever housing
Cut locking ties on harnessUsing the tilock-terminal housing extraction tool (PN 755430-2), push the wires of the ing grip harness out of connector housingthe position of the wires for reinstallation