2004 Ski-Doo REV Series Factory Service Manual, Page 321Get this manual
Section 08 REAR SUSPENSION Subsection 02 (SC-10 III SUSPENSION)
NOTE: If revalving is to be done, it is imperative that you identify the original shim pack (size and number of shims)The seal carrier need not be removed if only revalving is to be doneShims can be measured by using vernier caliper or micrometerNOTE: All shims should be carefully inspected and any bent or broken shims must be replaced for the shock to function properlyAfter the new or replacement shim pack has been selected, reassemble in the reverse order of disassemblyTorque piston nut to 2729 Nm (2021 lbfft)1 3
A32F1XA
Rebound dampening shim pack Rebound dampening shim pack Piston Compression dampening shim pack Compression dampening shim pack Stopper
If the seal carrier assembly is replaced, use seal pilot to guide seal over damper shaftLubricate seal carrier guide pilot before useCAUTION: Failure to use seal pilot will result in seal damageReassemble damper rod assembly, taking care to properly assemble shim packs as required for your dampening needsEnsure that the shaft piston is installed with the slitslarger intake holes facing the rebound shim stack