2004 Ski-Doo REV Series Factory Service Manual, Page 312Get this manual
Section 08 REAR SUSPENSION Subsection 02 (SC-10 III SUSPENSION)
COMPONENT REMOVAL AND INSTALLATION
Lift rear of vehicle and support it off the ground
Rear Axle
Remove screw on rear axle no21 on side of offset wheelCompletely loosen track tensionPull out rear axle from opposite side of offset inner wheelAt assembly, align spacer hole with adjusting boltMake sure to reinstall washer on each side of runner
A32F4BA
TYPICAL
Remove nut on top end of shock no23