2004 Ski-Doo REV Series Factory Service Manual, Page 304Get this manual
Section 08 REAR SUSPENSION Subsection 01 (SC-10 SUSPENSION)
COMPONENT REMOVAL AND INSTALLATION
Lift rear of vehicle and support it off the ground
Rear Axle
Remove screw on rear axle no21 on side of offset wheelCompletely loosen track tensionPull out rear axle from opposite side of offset inner wheelAt assembly, align spacer hole with adjusting boltMake sure to reinstall washer on each side of runner
A32F4BA
Remove nut on top end of rear shock no15Remove nut on bottom end of shockIn case of gas shocks, completely loosen stopper strap or unfasten one end of themInstallation is reverse of removal procedureCAUTION: Take care not to damage grease fittingA03F1LA