2004 Ski-Doo REV Series Factory Service Manual, Page 241Get this manual

2004 Ski-Doo REV Series Factory Service Manual, Page 241

Section 06 TRANSMISSION Subsection 02 (DRIVE PULLEY)
A16D2PB A32D1ZA

MODEL With TRA III

ANGLE (A) 45 3

Always install lever assemblies so that cotter pins are on the shown sideBesides install cotter pin head on top when lever is sat at bottom of sliding halfBend cotter pin ends to sit perfectly against lever
WARNING
Whenever replacing centrifugal levers, always replace all at the same timeOtherwise, drive pulley misbalancing will occur because of levers differenceCAUTION: Lever assemblies must be installed so that cotter pins are on the same side793 HO Engine Equipped Models Only

Back to 2004 Ski-Doo REV Series Factory Service Manual