2004 Ski-Doo REV Series Factory Service Manual, Page 200Get this manual
Section 05 2TEC ENGINE MANAGEMENT Subsection 02 (COMPONENT INSPECTION AND ADJUSTMENT)
For TPS and e-RAVE solenoid replacement procedures, refer to the respective paragraph in ELECTRONIC MANAGEMENT below
Adjustment
Throttle Body Synchronization CAUTION: It is not allowed to perform any change on the synchronization screwBefore installation, clean throttle plates and bores with Pulley flange cleaner (PN 413 711 809)NOTE: The throttle body is designed as single part for both cylindersNo synchronization is required as it has already been done at the factoryHowever, proceed with throttle cable and closed TPS adjustments as described below1 2
A32C9TA
1Idle speed screw 2Zero position stopper screw