2004 Ski-Doo REV Series Factory Service Manual, Page 150Get this manual

Section 04 ENGINE Subsection 03 (MAGNETO SYSTEM)
420 876 080

Disconnect trigger coil connector housing(s) grommet from crankcase where trigger coil wire(s) exit(s) magneto housing retaining screws no4 trigger coil(s) and carefully pull wires
ASSEMBLY
Trigger Coil
For installation, reverse the removal procedureNOTE: It is important to remove the old silicon at trigger coil location then apply new siliconScrew trigger coil then stick the trigger coil wires in the silicon
A03C1JB

TYPICAL 130 mm socket

Insert the stator connector into crankcase grommet then the trigger coil connector(s)Install the grommet on crankcase Position stator no6 so that its wire protectors are over crankcase recess2 1

• ATV
• Jet Ski
• Outboard Motors
• Personal Watercraft
• Snowmobiles
• Stern Drives