2004 Ski-Doo REV Series Factory Service Manual, Page 23Get this manual

2004 Ski-Doo REV Series Factory Service Manual, Page 23

INTRODUCTION
THREADLOCKER
Uncovered Holes (bolts and nuts)

Apply Loctite Primer (PN 293 800 041) on threads (bolt and nut) and allow to dry for 30 seconds Choose proper strength Loctite threadlocker Apply several drops along the threaded hole and at the bottom of the hole Apply several drops on bolt threads Tighten as required
Stud in Blind Holes

A00A3LA

1Apply here 2Do not apply

Clean threads (bolt and nut) with solvent Apply Loctite Primer (PN 293 800 041) on threads and allow to dry Choose proper strength Loctite threadlocker Fit bolt in the hole Apply few drops of threadlocker at proposed tightened nut engagement area Position nut and tighten as required

Back to 2004 Ski-Doo REV Series Factory Service Manual