2004 Ski-Doo Elite Factory Service Manual, Page 323Get this manual
Section 12 WIRING DIAGRAM Subsection 01 (WIRING DIAGRAM)
Cut both locking ties that secure the harness to the housing
Insert the probe into the housing as shown, and locate the appropriate wire in the back of the housingYou may have to slightly cam the probe against the locking tab to release it, then remove the terminal from the housing
F18Z0UA F18Z07A
1Locking ties
Turn the housing over and remove the lock by pushing and then pulling toward the wire harness
F18Z0VA
F18Z0SA