2004 Ski-Doo Elite Factory Service Manual, Page 294Get this manual
Section 10 BODYFRAME Subsection 01 (BODY)
CAUTION: Never touch glass portion of an halogen bulb with bare fingers, as it shortens its operating lifeIf by mistake glass is touched, clean it with isopropyl alcohol which will not leave film on the bulb
Taillight
If the taillight bulb is burnt, expose the bulb by removing red plastic lensTo remove, unscrew the retaining screwsVerify all lights after replacement
REARVIEW MIRROR
Removal
Remove the mirror from its back plateUnfasten the three bolts retaining the mirror back plate to the mirror baseA34H0SA
TYPICAL CUTAWAY
Installation
For installation, reverse the removal procedure
To remove decal; heat old decal with heat gun and peel off slowlyUsing isopropyl alcohol, clean the surface and dry thoroughlyApply liquid soap to new decal and carefully position the decalUsing sponge or squeegee, remove the air bubbles and surplus water working from the center toward the edgesAllow to air dryCAUTION: Do not apply isopropyl alcohol or solvent directly on decalsUse only in well ventilated area