2004 Ski-Doo Elite Factory Service Manual, Page 293Get this manual
Section 10 BODYFRAME Subsection 01 (BODY)
INSTALLATION AND ADJUSTMENT HEADLAMP BEAM AIMING
Beam aiming is correct when center of high beam is 25 mm (1 in) below the headlamp horizontal center line, scribed on test surface, 381 cm (12 ft in) awayMeasure headlamp center distance from groundScribe line at this height on test surface (wall or screen)Light beam center should be 25 mm (1 in) below scribed line
BULB REPLACEMENT
Headlamp
If any headlight bulb is burnt, open access door in dashboard
A34I02A
TYPICAL ACCESS DOOR REMOVED 1Connector 2Rubber boot 3Retainer ring
A02E0AA